Status Menu; Vacuum Mode - ID Technology 250 Operator / Technical Manual

Status Menu

The Status menu is used to review each parameter and it's current setting. By
using the up and down arrows, each item and the current value will be displayed.
This is helpful when setting another controller or recording settings in your manual.
It is not possible to alter any settings from this menu.

Vacuum Mode

The Vacuum mode is used to control the valve that supplies compressed air to the
vacuum generator. The vacuum generator is used to hold the label on the tamp
pad prior to application to the product.
Normal – In this state, the vacuum is always running when the unit is powered
up and there is a supply of compressed air available.
Conserve Air – This mode turns on the vacuum at the start of label feed and
turns it off when the apply cycle is complete. When operating in reverse print
mode or not printing labels in batches, this will reduce the amount of
compressed air the machine consumes and also reduce the amount of dirt and
debris that will be drawn in through the tamp pad.
Operators/Technical Manual
Model 250
Printer Applicator
Section Five
Section 5 Page 16 of 18