ID Technology 250 Operator / Technical Manual page 57

Model 250
Printer Applicator
Operators/Technical Manual Section 3A
Install the Tampjet module in port "P" of the pneumatics block.
Use your fingers to start the threading of the brass fitting into the port to ensure the
threads do not get cross threaded. (The brass fitting spins freely in the Male Run Tee)
Using an adjustable wrench, tighten the fitting into port "P". There is a washer on the
inside end of the fitting so it is not necessary to use teflon tape on the threads
Figure 3A-9 Location of Tamp-Jet connection
to pneumatic block. Side View
Section 3A Page 5 of 9