Installation Of The Tamp-Jet Module; Tamp-Jet Module Parts Connections - ID Technology 250 Operator / Technical Manual

The tamp-jet module is used to create a non-contact method of label application. Once
installed the application should follow the following sequence:
Printed label is dispensed onto tamp pad, tamp pad is extended to the full reach of the
cylinder, the product is detected by the sensor, after an operator designated delay a blast
of air is delivered to the label through the tamp pad, the label is propelled to the product,
the cylinder is retracted to the home position and is ready to receive another label.
Installation of the tamp-jet module should take about five
minutes.
Ensure power is disconnected from the unit.
Ensure plant air is disconnected from the unit.
Ensure you have received all the necessary components.
An Allen wrench is needed to remove the back cover. (M4
Cap head bolt)
A crescent wrench is needed to remove one of the fittings
from the manifold.
Refer to figure 3A-1 to see the tamp-jet module and Table
3A-1 to see a reference table of the connections that will
be used.
Table 3A-1 Tamp-Jet Module Parts connections
Ref # Association
1 Connects to Manifold
2 Connects to Plant air
3 Connects to Venturi system Transducer
4 Connects to Tamp Pad
5 Connect to J10 on the Electronics Module
Operators/Technical Manual
The 250 Label Applicator

Installation of the Tamp-Jet Module

Model 250
Printer Applicator
Section 3A
Figure 3A-1 Tamp-Jet
Module Connections
Section 3A Page 1 of 9