ID Technology 250 Operator / Technical Manual page 103

SYMPTOM
Label advance
does not occur
Labels not being
held on tamp pad
after label advance.
Label placement on
tamp pad
consistently poor.
Operators/Technical Manual
DIAGNOSIS
1. Product detector
incorrectly aligned.
2. Product detector
disconnected from
machine or cable
damaged.
3. Applicator not ON-LINE.
4. Printer not ON-LINE.
1. Vacuum venturi adjusted
incorrectly or exhaust
blocked.
2. Air assist tube out of
adjustment.
1. Air assist too high, too low
or incorrectly positioned.
2. Label stop out of
adjustment.
3. Insufficient vacuum due to
vacuum venturi control out
of adjustment.
4. Label detector sensitivity
out of adjustment.
5. Adhesive or other
obstruction on tamp pad
6. Die cut or adhesive strings
on label and liner.
Model 250
Printer Applicator
Section Six
SOLUTION
Refer to 250 manual for
set-up instructions.
Correct or replace as
necessary.
Press JOG/RESET button
on applicator.
Correct.
Inspect and correct.
Refer to 250 manual for
adjustment.
Refer to 250 manual for
set-up instructions
Refer to Sato manual for
adjustment.
Inspect and correct.
Refer to Sato manual for
adjustment.
Clean tamp pad.
Replace label roll.
Section 6 Page 10 of 20