ID Technology 250 Operator / Technical Manual page 104

SYMPTOM
Label placement on
product consistently
poor.
Tamping does not
occur.
Air assist does not
work
Operators/Technical Manual
DIAGNOSIS
1. Fluctuation of product
conveyor speed.
2. Poor label adhesive.
3. Poor product guidance.
4. Product detector not
correctly positioned.
5. Incorrect product delay.
6. Smart tamp sensor out of
adjustment.
7. Poor placement of label
onto tamp pad.
1. Applicator not connected
to air supply or air
pressure regulator turned
down.
2. Tamp solenoid or control
electronics malfunction.
3. Faulty Interface PCB.
4. Smart Tamp sensor not
working.
1. Applicator not connected
to air supply or air
pressure regulator turned
down.
2. Air solenoid or control
electronics malfunction.
3. Faulty Interface PCB.
Model 250
Printer Applicator
Section Six
SOLUTION
Inspect and correct
Report to label
manufacturer if problem
persists.
Inspect and correct.
Refer to 250 manual for
set-up instructions.
Refer to 250 manual for
set-up instructions.
Inspect and correct.
Refer to "Label placement
on tamp pad consistently
poor"
Inspect air pressure gauge
and correct as necessary.
Request qualified service
assistance.
Replace.
Inspect and correct or
replace.
Inspect air pressure gauge
and correct as necessary.
Request qualified service
assistance.
Replace.
Section 6 Page 11 of 20