ID Technology 250 Operator / Technical Manual page 60

Model 250
Printer Applicator
Operators/Technical Manual Section 3A
Connect the electrical plug from the tamp module to the electronic module of the
applicator. Run the wire up through the bottom of the electronics module as shown in the
figure below. (Arrow shows the knock out on the elctronics module that can be used to
thread the wire through.) The connector goes on pin J10. As illustrated by the blue wire
in figure 3A-12 below.
Figure 3A-12 Electrical connection of tamp-jet module to
electronics module on the applicator.
Section 3A Page 8 of 9