Location Of Pneumatics Module; Location Of One Touch Brass Fitting. Back View; Location Of One Touch Brass Fitting. Side View - ID Technology 250 Operator / Technical Manual

Model 250
Printer Applicator
Operators/Technical Manual Section 3A
Locate the pneumatics module. After
removal of the back cover the module is
located to the left side as you are facing the
back. Fig. 3A-6 shows the location of the
pneumatics module with the arrow.
Remove the air tubing that goes from the
applicators plant air filter on the u-arm to the
pnuematics block. The one touch brass
fitting on the bottom of the pneumatics block
(in center marked "P" pressure) can be
removed using a small adjustable crescent
wrench. Remove the fitting located in port
"P" on the bottom of the pneumatics block.
See figures 3A-7 and 3A-8 for the location of
the fitting.
Figure 3A-6 Location of pneumatics module.
Figure 3A-7 Location of one Figure 3A-8 Location of one
Touch brass fitting. Back View. Touch brass fitting. Side View.
Section 3A Page 4 of 9