Agilent Technologies 1100 Series Reference Manual page 87

print sendmodule$(lthm, "ser YYYYYYYYYY")
Where: YYYYYYYYYY is the 10-character serial number of the module in
question.
The first two characters are letters, which should be capitalized.
NO TE
The reply line will respond with RA 0000 SER followed by the module serial
number you just entered.
2 Turn off the column compartment, then on again. Then, re-boot the
3 After boot-up, the serial number you have just entered can be seen under
print sendmodule$ (lthm, "ser?")
The reply line will give the module serial number.
1100 Series TCC Reference Manual
ChemStation. If the serial number you have just entered is different than
the original module serial number, you will be given the opportunity to edit
the configure 1100 access screen during the re-boot of the ChemStation.
the Instrument menu of the main user interface screen. The serial number
of the column compartment can also be seen by typing the following
command into the command line:
Repairing the Column Compartment
4
77