Gpib Default Addresses; Communication Settings For Rs-232C Communication - Agilent Technologies 1100 Series Reference Manual

6
Introduction to the Column Compartment
Here the parameters are kept, independently if you turn the column
compartment off and on again. They will be kept until the same set of
parameters is subsequently changed and power is reset. All other previously
stored configuration settings are still being kept in non-volatile memory.
In this manner you can store more than one set of parameters, for example, for
GPIB and RS-232C, using the same 8-bit configuration switch twice.

GPIB Default Addresses

If you just want to change the GPIB address and need a detailed procedure,
refer to the Installing Your Agilent ChemStation System handbook. Default
GPIB address is set to the following addresses:
Table 38
Module
Pump
FLD
VWD
Agilent 8453A
DAD/MWD
Column compartment
Autosampler
RID
where 0 means that the switch is down and 1 means that the switch is up.

Communication Settings for RS-232C Communication

The communication protocol used in the column compartment supports only
hardware handshake (CTS/RTR).
Switches 1 in down and 2 in up position define that the RS-232C parameters
will be changed. Once the change has been completed, the column instrument
must be powered up again in order to store the values in the non-volatile
memory.
158
Default Addresses for Agilent 1100 Series Modules
Address
22
23
24
25
26
27
28
29
Binary Address
0 0 0 1 0 1 1 0
0 0 0 1 0 1 1 1
0 0 0 1 1 0 0 0
0 0 0 1 1 1 0 1
0 0 0 1 1 0 1 0
0 0 0 1 1 0 1 1
0 0 0 1 1 1 0 0
0 0 0 1 1 1 0 1
1100 Series TCC Reference Manual