Agilent Technologies 1100 Series Reference Manual page 71

10 Place the new (if required) ceramic stator face in place on the stator head.
11 Insert the stator screws in the stator head. Tighten the screws alternately
12 Reconnect the pump capillaries to the valve ports. Slide the waste tube into
13 Perform a pressure-tightness test to ensure the valve is pressure tight to
Figure 14
1100 Series TCC Reference Manual
Reinstall the stator head.
two turns at a time until the stator head is secure.
the waste holder in the leak tray.
400 bar.
Stator ring
Stator face
Stator head
Stator screws
Column Switching Valve Parts
Repairing the Column Compartment
Isolation seal
Rotor seal
Spring shows to
rear
4
61