Command Syntax
Parameters
Command Access
Command Syntax
Command Access
Command Syntax
Parameters
Chapter 8: Using the Command Line Interface (CLI)
set telnet [disabled | enabled]
set telnet port <port>
The set telnet command uses the following parameters:
set trend [disabled | enabled]
set unit assettag <name | id> <asset tag>
set unit display [auto | inverted | normal] <name | id | ALL>
set unit email [disabled | enabled] <name |id | ALL>
set unit identify [disabled | enabled] <name | id | ALL>
set unit name <name | id> <new name>
For Switched PRO2 products only:
set unit osequence [normal | reversed] <name | id | ALL>
set unit odisporder [normal | reversed] <name | id | ALL>
Confirmation required:
set unit purge <name | id | ALL>
set unit snmpt [disabled | enabled] <name | id | ALL>
The set unit command uses the following parameters:
PRO2 User Guide
•
216
Need help?
Do you have a question about the PRO2 and is the answer not in the manual?