Server Technology PRO2 User Manual page 207

Command Syntax
Parameters
Sub-Parameters
Command Access
Command Syntax
Chapter 8: Using the Command Line Interface (CLI)
set phase email [disabled | enabled] <name | id | ALL>
set phase pf [alarmlo | warnlo] <name | id | ALL> <value>
set phase snmpt [disabled | enabled] <name | id | ALL>
set phase volts [alarmhi | alarmlo | warnhi | warnlo] <name | id | ALL> <value>
set phase volts hyst <value>
For AC products only:
set phase pf hyst <value>
The set phase command uses the following parameters:
The set phase command uses the following sub-parameters:
set port [baud | speed] [1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 115200]
<name | id >
set port dsrcheck [disabled | enabled] <name | id >
set port timeout <name | id > <timeout>
PRO2 User Guide
•
207