Command Syntax
Parameters
Sub-Parameters
Command Access
Command Syntax
Parameters
Command Access
Chapter 8: Using the Command Line Interface (CLI)
set sntp dst [disabled | enabled]
set sntp dst [end | start] <tz string>
set sntp gmtoffset <offset>
set sntp primary <hostname>
set sntp secondary <hostname>
The set sntp command uses the following parameters:
The set sntp command uses the following sub-parameters:
set spm [disabled | enabled]
set spm resetpw
The set spm command uses the following parameter:
PRO2 User Guide
•
213
Need help?
Do you have a question about the PRO2 and is the answer not in the manual?