Setting Values In Tenths Of Units Above 100 - Lenze SM004S Operating Instructions Manual

4 Commissioning
Use the p and q buttons to scroll to the desired parameter number. In the example below, Parameter
19 is being displayed, which is the ACCELERATION TIME of the drive:
Use p and q to scroll to the desired
parameter number (the example is
Parameter 19 - ACCELERATION TIME)
Once the desired parameter number is found, press the Mode button to display the present parameter
setting. The upper right-hand decimal point will begin blinking, indicating that the present parameter
setting is being displayed, and that it can be changed by using the p and q buttons.
Press Mode to display present
parameter setting (example setting
is 20.0)
Upper right decimal point blinks
Use p and q to change setting
(example setting changed to
30.0)
Press Mode to store new setting
Pressing Mode will store the new setting and also exit the PROGRAM mode. To change another
parameter, press the Mode key again to re-enter the PROGRAM mode (the parameter menu will
be accessed at the parameter that was last viewed or changed before exiting). If the Mode key is
pressed within two minutes of exiting the PROGRAM mode, the password is not required access the
parameters. After two minutes, the password must be entered in order to access the parameters again.
4.2.1

Setting Values in Tenths of Units Above 100

Parameter settings and the keypad speed command can always be adjusted in tenths of unit
increments from 0.0 to 99.9. Above 100 however, values can be set in whole units or tenths of units,
depending on the setting of Parameter 16 - UNITS EDITING.
If Parameter 16 - UNITS EDITING is set to WHOLE UNITS (02), parameter values and the keypad speed
command can only be adjusted by whole unit increments above 100. For example, Parameter 19 -
ACCELERATION TIME could not be set to 243.7 seconds. It could only be set to 243 or 244 seconds.
Likewise, the keypad speed command (set using the p and q buttons) could not be set to 113.4 Hz.
It could only be set to 113 or 114 Hz.
If, however, Parameter 16 - UNITS EDITING is set to TENTHS OF UNITS (01), parameter values and the
keypad speed command can be adjusted in tenths of unit increments up to a value of 1000 (above
1000, whole unit increments only). Each push of the p or q button will adjust the value by one tenth
of a unit. If the p or q button is pressed and held, the value will increment by tenths of units until
the next whole unit is reached, and then the value will increment by whole units.
28
Lenze 13466147 EDBSM01 v19 EN