Installation - Martin Alien 05 User Manual

I N S T A L L A T I O N
To install the Alien 05:
1 Cut a round hole with a
diameter of 182 mm (7.2 in) in
the panel in which the Alien 05
is to be installed. Note that it
may be advisable to perform
this step for all the Alien 05s
that are being installed and to
t h e n l ay t h e p o w e r a n d
network leads between each
mounting hole.
2 Connect the power leads from
the 12 V AC halogen lamp
transformer. Anchor these securely by tightening the screws.
3 Connect a CAT5 network cable from the 05 Driver unit and, if the lamp is to be daisy-
chained to a subsequent lamp, connect a CAT5 network cable for the link to that
fixture. Note that it does not matter which network socket is used.
4 Once the cables are connected, insert the Alien 05 into the mounting hole.
8
Power
cables from
transformer
(12 V AC)

Installation

182 mm
182 mm
CAT5
network
cables