Table of Contents
Advertisement
Physical installation
Warning! Read 'Safety information' on page 4 before
installing the fixture.
The fixture is designed for indoor use only and must be used in
a dry location with adequate ventilation. Ensure that none of the
fixture's ventilation slots are blocked.
Fasten the fixture to a secure structure or surface. Do not stand
it on a surface or leave it where it can be moved or fall over. If
you install the fixture in a location where it may cause injury or
damage if it falls, secure it as directed in this user manual using
a securely anchored safety cable that will hold the fixture if the
primary fastening method fails.
Do not use the fixture to illuminate surfaces within 0.5 m (20 in.)
of the fixture.
Martin™ can supply safety cables and rigging clamps that are suitable for use
with the fixture (see 'Accessories' on page 31).
Standing the fixture on the floor
The fixture may be used free standing on the floor by spreading the two
mounting brackets apart.
Fastening the fixture to a flat surface
The fixture can be fastened to a hard, fixed, flat surface. Ensure that the
surface and all fasteners used can support at least 10 times the weight of all
fixtures and equipment they will support.
Fasten the fixture securely. If you install the fixture in a location where it may
cause injury or damage if it falls, secure it as directed below with a securely
anchored safety cable that will hold the fixture if the primary fastening method
fails.
Mounting the fixture on a truss
The fixture can be clamped to a truss or similar rigging
structure in any orientation. When installing the fixture
hanging vertically down, you can use an open-type clamp
such as a G-clamp. When installing in any other orientation,
you must use a closed-type rigging clamp such as half-
coupler clamp (see illustration on right) that completely
encircles the truss chord.
10
RUSH PAR 4 UV
User Manual
Advertisement
Table of Contents
