SHINOLA 5021.D Manual page 10

ACCUMULATED TIMING
Example
Start: start timing.
1
2 Stop: e.g., 15 min. 5 sec . following 1
3 Restart: timing is resumed.
4 *Stop: e.g., 13 min. 5 sec. following 3
The accumulated time = 28 min. 10 sec.
Reset: The three chronograph hands
5
are returned to their zero positions.
Please note:
* Following 4 , the accumulation of the timing can be
continued by pressing push-button A
INTERMEDIATE OR INTERVAL TIMING
Example
Start: start timing.
1
2 Display interval:
e.g., 10 min. 10 sec. following 1 .
Timing continues in the background.
*
3 Making up the measured time:
the three chronograph hands are quickly
advanced to the ongoing measured time.
4 Stop: e.g., 28 min. 10 sec. following
5 Reset: The three chronograph hands are
returned to their zero positions.
Please note:
* Following 3 , further intervals or intermediates can be
displayed by pressing B (display interval / make up measured time, ...)
1
.
A
.
B
5
(Restart/Stop, Restart/Stop,...)
A
1 .
B
18
MOON PHASE MODEL 708
4
SETTING THE TIME
3
2
Pull out the crown to position
1
(the watch stops).
2 Turn the crown until you reach the
correct time.
3 Push the crown back into position I.
SETTING THE DATE
1 Pull out the crown to position
(the watch continues to run).
2 Turn the crown until the correct date appears.
3 Push the crown back to position I.
SETTING THE MOON PHASE
1 Pull out the crown to position
(the watch stops).
4
1
2 Turn the crown until you reach the correct moon
position. Be sure to match the position to accurate
moon phase (use a lunar calendar). The moon disc
moves very slowly by incrementally jumping every
24 hours (each date change).
3 As time function rotates on position III, the hands
will move while setting moon phase. Once accurate
moon phase is achieved, set the hour and minute
2
hands back to the correct time.
3
5
Be sure to reset the date indicator to correct date
4
(refer to SETTING THE DATE instructions above).
III
708
II
708
708
III
7 0 8
708 708
19
1
I II III
2
3
1
I II
2
3
1
I II III
2 3
4