SHINOLA 5021.D Manual page 11

GMT MODEL 515.24H
If your 24-hour watch features a date indicator, the date window might be in a different position
from the one depicted in this manual.
SETTING THE TIME
Pull out the crown to position III.
1
(The watch stops.)
2 Turn the crown until you reach the
correct time.
3 Push the crown back into position I.
SETTING THE 24-HOUR INDICATOR
Pull out the crown to position II.
1
(The watch continues to run.)
2 Turn the crown counterclockwise
until you reach the correct time.
3 Push the crown back to position I.
SETTING THE DATE
1 Pull out the crown to position II.
(The watch continues to run.)
2 Turn the crown clockwise until the
correct date appears.
3 Push the crown back to position I.
4 If performing a quick date setting between
10:30 p.m. and 12:00 a.m., follow steps 1
through 3, but be sure to set the date to the
following day, as there will be no change at midnight.
1
I II III
31 31
3
1
I II
31 31
31 31
3
1
I II
31 31
3
20
DAY & NIGHT (GMT) MODEL 515.24D
QUICK-CHANGE CORRECTION FOR DATE
Pull out the crown to position II. (Watch still runs.)
Turn the crown clockwise until the
required date appears.
Push the crown back into position I.
2
NOTE: The date can also be corrected during
the day-changing phase between 10 pm and
midnight. The date of the following day has to
be set, because no automatic date change
takes place at midnight.
QUICK-CHANGE CORRECTION FOR 24-HOUR DISPLAY
2
Pull out the crown to position II. (Watch still runs.)
Turn the crown counterclockwise until the
required date appears.
Push the crown back into position I.
SETTING THE TIME
2
Pull out the crown to position III.
(The watch stops.)
Turn the crown until the current time is shown
(remember the 24-hour cycle).
Push the crown back into position I.
21