Material Menu; Password; Factory Reset - Check-line DTS-200 Operating Manual

4.3

Material Menu

In the material menu you can make the settings for the selected material characteristics
and perform the calibration. To perform the calibration, the weights for the selected
calibration points must be available.
Material Setup
No. of the
characteristic-
material curve
1 - 5
Damping
Alarms
High Limit
Low Limit
Calibration 6.1
4.4

Password

Setting a password blocks the access to some menu parts for unauthorized users:
0000
0001 – 0999
1000 – 9999
NOTE: To apply a changed password, exit the main menu. Entering 0000 as the
password disables the password feature. If you forgot the password, please contact
the factory to request the master password. As an alternative, you can perform a factory
reset. Please note, that in this case, you will lose any customer-defined calibrations.
4.5

Factory Reset

A factory reset resets the tension meter to its original manufacturer settings.
This procedure will delete all settings, including any customer-defined material
characteristics (calibrations); the factory calibration, however, will be kept.
Customer calibrations will be deleted.
Submenu Settings Menu
— [character],
[numbers],
special character]
— [1] – [9]; [5]
— [ON], [OFF]
[0000] - [9999]
—
[0000] - [9999]
Start
between [10 %] and
Cal. Points [100 %] of the tension
range
Weights [cN/daN] [g/kg]
All menus are accessible.
The Material, Cal. Adjustment, Settings, and Memory Settings menus
are locked
The entire menu is locked.
Description
To enter a name for the selected material
characteristic.
Section 5.5
To activate or deactivate the alarm function for the
material characteristic.
Activate/deactivate the alarm for all calibrations.
The alarm of a material characteristic is only active if
the [Alarm] menu item in Material Setup is activated
as well.
Activate/deactivate the peak values in the bar graph
display.
To perform a calibration, follow the instructions shown
on the display.
Set three calibration points for which a calibration
should be performed.
Set the unit of the calibration weights used.
– 8 –