Memory Functions; Save Data; Displaying The Saved Measured Values; Deleting The Saved Measured Values - Check-line DTS-200 Operating Manual

6.3

Memory functions

You can store and display the statistics of one measuring series (last measured value,
the average, the minimum and maximum measured values, the peaks, the standard
deviation).
Data is recorded during a user-defined period.
6.4

Save data

1. Press the
2. While recording is in process, "Rec S" flashes on the display.
3. Press the
4. To save the recorded data, press the
Data, stored in the memory before, will be overwritten.
5. Press the
without saving
NOTE: To abort data recording, press the button. This stops
the procedure. No data will be saved.
6.5

Displaying the saved measured values

1. Press the Recall
The display will only show statistical values
Name of the material to be measured
Date and time of the measurement series
Last reading
Average
MAX.
6.6

Deleting the saved measured values

If data is saved in the tension meter, the display shows "Mem" .
Deleting data:
1. Press the Recall
2. Then press the
This clears the memory.
button to start recording the measured values.
button again to stop recording.
button to stop recording the measured values
and buttons simultaneously to display the saved data.
and buttons
button and confirm with the
button (the display shows "Mem S").
MIN.
PEAK max.
PEAK min.
Standard deviation (Std. Dev.)
Number of measured values
– 19 –
FIG. 15
button.