Table of Contents
Advertisement
Connecting the USB Smart Cable to the
Development Board
Observe the following steps to connect the USB Smart Cable to the Development Board.
The power to the development board must be disconnected or turned off
Caution:
before connecting or disconnecting the USB Smart Cable.
1. Attach one end of the six-conductor ribbon cable (included) to the USB Smart Cable
six-pin DBG connector (see Figure 1).
2. Attach the free end of the ribbon cable to the DBG connector on the development
board. Ensure that pin 1 on the ribbon cable (indicated by the dark stripe) is aligned
with pin 1 on the target connector.
Figure 1. Connecting the Six-Conductor Ribbon Cable
Connecting the Serial Smart Cable to your Development
Board
If you are using a Z8 Encore! XP
your PC communicates with the development board through the serial port. The Z8
Encore! XP Serial Smart Cable converts the RS-232 signals into the 3.3 V bidirectional
open-drain signals required to communicate with the On-Chip Debugger (OCD).
QS002810-0111
Z8FMC16100 Series Motor Control Development Kit
to the USB Smart Cable
®
F64XX Series Kit supplied with a Serial Smart Cable,
Quick Start Guide
Page 7 of 12
Advertisement
Table of Contents
