ZiLOG Z8 Encore! XP Quick Start Manual page 6

Windows XP
Observe the following steps to install the USB Smart Cable for Windows XP.
1. Connect the Zilog USB device to the Host PC. The
should activate automatically after connecting the Zilog USB device for the first time;
Select
No, not at this time
2. Select
Install from a list or specific location (Advanced)
Note:
If the Windows Logo testing dialog appears, select
3. Select Search for the best driver in these locations
.
search:
4. Browse to the following directory and click
<ZDS installation>\device drivers\USB\x32
5. Find the appropriate driver, and click
6. Click Finish to complete the installation.
Windows 2000
Observe the following steps to install the USB Smart Cable for Windows 2000.
1. Connect the Zilog USB device to the Host PC. The
should activate automatically after connecting the Zilog USB device for the first time.
2. Click in the
Next
3. Select
Search for a suitable driver for my device (Recommended)
4. Select
Specify a location
5. Browse to the following directory and click
<ZDS installation>\device drivers\USB\x32
6. Find the appropriate driver, and click
7. Click to complete the installation.
Finish
QS002810-0111
Z8FMC16100 Series Motor Control Development Kit
if asked to connect to Windows
Found New Hardware
and click
Next
Found New Hardware
and
:
Next
Next .
Found New Hardware
Wizard after it has been activated.
.
:
OK
.
Next
Quick Start Guide
Wizard
®
Update.
and click .
Next
Continue Anyway
Include this location in
Wizard
and click
Page 6 of 12
.
.
Next