Table of Contents
Advertisement
REGULAR MAINTENANCE
TRANSPORT CLUTCH ADJUSTMENT
WARNING
NEVER have safety covers off with engine on.
It is very dangerous if the transport clutch
does not work properly.
Stop machine if you feel abnormal movement.
1. Shift the brake handle down for transport.
2. If the transport clutch wire is loose extend
the wire by adjusting the wire adjusting nuts
on each side of the metal brace.
Clutch Wire Adjuster
20mm length
The threaded part of the wire on the side of the metal
brace closest to the rotor should be approximately
20mm when brand new. This may change slightly
with age so always check if the transport clutch is
engaging the transport belt efficiently at the source.
3. Tighten the wire adjusting nuts securely.
4. Release the brake handle up and replace the covers.
Start engine and confirm that the transport clutch
is fully disengaged.
5. When elasticity of transport belt weakens such
that it can not be engaged by adjusting transport
clutch wire, replace the transport belt.
TURNING CONTROL LEVER ADJUSTMENT
When the side clutch does not work properly or
machine does not turn smoothly, adjust wires for
the side clutch.
1. So that the gears in the gear box remain
correctly engaged, first without touching the
turning control levers, start the engine and
move the machine straight forward 2~3 metres.
Clutch Wire Adjuster
2. Adjust the side clutch wire adjusting nuts on
each side of the metal brace until the
turning handle responds as desired when
engaged.
3. Tighten the adjuster nuts securely.
- 27 -
Advertisement
Table of Contents
