Table of Contents
Advertisement
FEED ROLLER CLOGGING RELEASE
DANGER
Ensure the engine and chipping components
have come to a complete stop before attempting
to release any clogged material from the machine.
Do not use your hands to remove materials stuck
in the feed roller.
Use a wooden broom or other wooden instrument
to remove stuck materials.
Do not place hands near the feed roller / feed box.
Be careful of the feed roller and feed box when
clogged material is released from under the feed
roller. When clogged material is released, the
feed roller suddenly drops down and would crush
a persons hands.
Avoid injury and be very careful of sharp knives
when unclogging the rotor.
1. Move the rotor clutch lever and then the engine
switch to the OFF position.
2. Wait for all engine parts and chipping
components to stop moving.
3. Move the rotor clutch lever to the ON position
which will stabalize the rotor.
4. Open the rotor cover.
5. Unclog the rotor of clogged materials.
6. Replace the rotor clutch lever to the OFF
position.
7. Lightly and carefully rotate the rotor manually to
check it is revolving freely without obstruction.
8. Close and secure the rotor cover.
9. Pull the feed roller release lever to raise the
feed roller.
Release
10. Any remaining clogged material can be
removed via the hopper.
Note
If the fuse 7.5A is blown, the feed rollers will stop
working. Replace the fuse.
11. Should the feed material become lodged
in the feed roller teeth, remove the left hand
side cover and manually turn the feed belt
anti-clockwise until the struck material
become loose and can be removed.
- 22 -
Advertisement
Table of Contents
