How To Operate Machine - OHASHI ES72G Operation Manual

HOW TO OPERATE MACHINE

DANGER
Read the Pre-Operating Safety
Checklist
and Pre-Operating Machine Checklist
before starting the engine.
Whenever the terms "Right", "Left", "Forward"
and "Reverse" are used in this manual, they
indicate the directions from the operator
facing forward looking into the hopper.
STARTING THE ENGINE
1. Make sure that the Brake Handle is in the UP
position.
2. Rotor clutch lever should be in the "OFF"
position.
ON
BRAKE HANDLE
OFF
- 15 -
3. Turn the fuel cock to "OPEN"
4. If cold move the choke lever to CLOSED before
starting the engine. Move back to OPEN after
engine starts.
5. If engine is not cold, you may start engine with
choke in the OPEN position.
CLOSE
6. Switch the Engine Switch to ON.
7. Grasp recoil start cord , to a compression
position, pull smoothly and with sufficient vigor.
8. After the engine starts, allow the engine to warm
up for 1-2 minutes with low running speed.
CAUTION
If recoil start cord is used 3 or more time in a row
engine may flood. Move the choke lever to OPEN
and throttle lever to full throttle and try again.
Too much fuel in the engine cylinder makes it
difficult to start the engine.
CLOSE
OPEN
OPEN
OFF
ON