Dispatch Unit Angle - OHASHI ES72G Operation Manual

CHIPPING OPERATIONS
DANGER
1. Read the Pre-Operating Safety Checklist
and Pre-Operating Machine Checklist before
starting the chipping operation.
2. Make sure that no metals, steels, stones,
sand etc. are contained in the woods to
be chipped / shredded before starting
the operation.
3. During chipping operation:
a) When the chipping operation is carried out,
the brake handle must be up.
b) The chipping work must be carried out only
when the engine is running at full throttle.
c) Pay attention to machine noise when the
machine is operated in a place where
people are living.
4. Pay attention to the muffler and surrounds
because it becomes very hot during the
operation and after operation.

DISPATCH UNIT ANGLE

1. Chips are dispatched swiftly from the dispatch
unit. Therefore, before starting the operation,
decide the dispatch unit angle and securely fix
the dispatch unit in position.
2. Dispatch angle can be adjusted.
BALANCE STAND
1. Set the balance stand so that the machine
is stable.
CAUTION 1
Do not face the dispatch unit towards the
engine so as to protect the engine from dust.
CAUTION 2
During operation, ensure there are no obstacles,
people or small children near the machine.
ROTOR CLUTCH
1. Make sure that the rotor clutch lever is OFF
completely before engine starts.
Move the engine throttle lever to the high
position, running the engine in full throttle.
2. Slowly move the rotor clutch lever from the
OFF position to the ON position checking
that there is no extra-ordinary vibrations.
Hold the rotor clutch lever in the middle
position between OFF and ON for 5 seconds,
before fully moving it to the ON position.
4. The machine should be operated for chipping
at the maximum engine speed only.
5. To stop the rotor place the rotor clutch lever
in the OFF position.
6. To stop the rotor quickly, turn throttle lever to
low before turning the rotor clutch lever OFF.
CAUTION
The engine will stop suddenly or a belt will
be damaged if the rotor clutch lever is shifted
to the ON position suddenly.
Therefore, always move the the rotor clutch
lever SLOWLY from OFF to ON.
- 19 -
Rotor Clutch lever