OHASHI ES72G Operation Manual page 17

PRE-OPERATING MACHINE CHECKLIST
To keep machine in top working condition, comply strictly with the following instructions.
1. CLEAN air cleaner
2. CHECK engine oil level, cleanliness and for any spillage (SE grade or above)
3. CHECK for cracks and / or wear on the chipper knives
4. CHECK for cracks and / or wear on the counter knife
5. CHECK for cracks and / or wear on the shredder knives and that the knives axle is secure
6. RETIGHTEN the bolts of chipper knives and counter knife
7. GREASE Lubrication Points as per the User Manual Lubrication Chart using a lithium grease
8. LUBRICATE machine parts as per the User Manual Lubrication Chart and ensure machine
has sufficient transmission oil, and gasoline
9. CLEAN engine and track crawlers.
10. CHECK for incorrect tension, cracks and / or wear of belts and chains
11. LUBRICATE with Shell Spirax S3 T 15W-40 oil, WD-40 or its equivalent all wire and lever
supporting points and any friction and sliding sections
12. RECORD the hours indicated on the Hour Metre.
13. CHECK that the tension of the wires engaging the parking brake, side clutch, transport clutch
and rotor clutch is appropriate and effective.
Notes:
※1 Engine oil must be replaced in first 25 hours and then every 50 hours.
※2 Shredder knives are optional
※3 Shell Spirax S3 T 15W-40; Gasoline unleaded
Refer to the User Manual List of Consumable Parts and the Regular Service and Maintenance
sections for parts details and instructions for regular service and maintenance.
※ 3
- 14 -
※ 1
※ 2