MacDon M205 Operator's Manual page 270

4. Press the REEL UP switch (A) on the GSL to raise the
center-link until the hook is above the attachment pin on
the header.
5. Drive the windrower slowly forward until the windrower
feet (A) enter the header supports (B). Continue driving
slowly forward until the feet engage the supports and
the header nudges forward.
6. Use the following GSL functions to position the
center-link hook above the header attachment pin:
•
REEL UP (A) to raise the center-link
•
REEL DOWN (B) to lower the center-link
•
HEADER TILT UP (C) to retract the center-link
•
HEADER TILT DOWN (D) to extend the center-link
214603
OPERATION
Figure 4.185: Ground Speed Lever
A
Figure 4.186: Header Support
D
Figure 4.187: Ground Speed Lever
250
A
B
B
A
C
Revision A