Configuring Tcp/Ip Settings - Honeywell PX4i User Manual

Use the following table to understand SNMP settings.
Setting
Read Community
Read/Write Community
Username
Authentication Key
Encryption Key
System Name
Authentication Failure
Trap
Trap Address Settings

Configuring TCP/IP Settings

Use the TCP/IP settings page to view and change TCP/IP network settings.
To configure TCP/IP settings
1. Click Network Admin > TCP/IP.
2. View or update your settings.
3. Click Submit TCP/IP settings.
PX4i and PX6i High Performance Printer User Guide
Description
Community with rights to read the SNMP MIBs.
Community with rights to read and write SNMP MIBs.
Username when using SNMPv3. The default value is "initial".
The authentication key for SNMPv3. The default value is "auth_key".
The privacy key for SNMPv3. The default value is "priv_key".
Administrative name for the SNMP node.
Defines if a trap is sent when an unauthorized SNMP request tries to
access the printer. Choose Enable to send the trap.
Click Add to specify these trap address settings:
• Trap Address: IP address of the receiver of SNMP traps. You can
specify up to four trap addresses.
• Trap Port: The port where SNMP traps are sent. The default port if
162.
• Trap Community: Defines the community to which SNMP traps will
be sent.
• Friendly Name: A user-defined text string that identifies the trap.
• Trap Enable Status: Defines whether the specified trap is enabled.
73