Toggle Settings - Honeywell PD45 User Manual

If any of these things occur, you probably have an unbalanced printhead. The
printer is adjusted at the factory for full-width media.
If you are using media that is less than full-width (4 inches or 102mm), adjust the
position of the toggle as necessary to provide the even pressure on the media.

Toggle Settings

Item Scenario
1 Thin media or the media and ribbon
requires lower pressure to print well or
DT media
2 Thick media or the media requires
high pressure to print well
3 Light Printing on the left side of the
label
4 Light Printing on the right side of the
label
5 Media moves from left side to right
side during printing
6 Media moves from right side to left
side during the printing
7 Media and ribbon slippage during
printing at retract mode
8 Narrow media (less than 2inch)
PD45S User Guide
Printhead Toggle Setting
Decrease the pressure on both left and right
toggles.
Increase the pressure on both left and right
toggles.
Increase the pressure on the left toggle.
Increase the pressure on the right toggle.
Increase the pressure on the left toggle or
decrease the pressure on the right toggle.
Increase the pressure on the right toggle or
decrease the pressure on the left toggle.
Increase the pressure on both left and right
toggles.
Move the left toggle to the center of the media
and decrease the pressure on the right toggle.
25