Loading Media For Tear-Off Printing - Honeywell PX4i User Manual

•
•
•
•
If you are using Fingerprint, use the
change the media type, or if the printer does not feed the media properly, simulta-
neously press the
If you are using IPL, save the label with the sensitivity number attached to the
media roll. You need this number to set the media sensitivity.

Loading Media for Tear-Off Printing

In tear-off, or straight-through, printing mode, you manually tear off the media
against the printer's tear bar. In tear-off mode, use these types of media:
•
•
•
•
•
You can also install an optional label taken sensor so that the next copy in the
batch is not printed until the current copy is removed. For more information, see
"Accessories for the Printer" on page 124.
If you are running Fingerprint, use the
you switch to a new type of media, or if the printer does not feed out the media
properly, simultaneously press the
If you are running IPL, save the label indicating the sensitivity number attached to
the media roll. You need this number to set the media sensitivity.
To load media for tear-off printing
1. Turn off the printer.
6
Cut-off
Batch take-up
External supply
RFID
Shift and
Non-adhesive continuous stock
Self-adhesive continuous stock with liner
Self-adhesive labels with liner
Tickets with gaps (gap stock), with or without perforations
Tickets with black marks (mark stock), with or without perforations
Feed key to load the same type of media. If you
Feed keys to perform a "testfeed."
Feed key to load the same type of media. If
Shift and Feed
PX4i and PX6i High Performance Printer User Guide
keys to perform a "testfeed."