Adjusting The Label Taken Sensor; Maintaining The Printer - Honeywell PX4i User Manual

2. Print test labels to check the print quality. For help, see "Printing a Test
To return the printhead pressure to the factory default setting
Tighten the knob (+) as much as you can, and then loosen it (-) four full turns.

Adjusting the Label Taken Sensor

If you are using the optional label taken sensor (LTS), you may need to adjust the
sensitivity depending on ambient light conditions and the reflective characteristics
of the back side of the media.
To adjust the LTS
1. Press
•
•
2. Modify one or more LTS settings.
Setting
LTS Adjust
LTS Test
LTS Value

Maintaining the Printer

To keep your printer working properly, you should perform regular maintenance.
100
Label" on page 45.
to enter the Setup menu, and use the keypad to go to the LTS menu:
Setup
If you are running Fingerprint, go to SETUP > PRINT DEFS > LTS.
If you are running IPL, go to SETUP > TEST/SERVICE > LTS.
How to Modify
Step 1.
Step 2.
Step 3.
Step 1.
Step 2.
Step 3.
Step 4.
Step 1.
Step 2.
Enter
Press . The printer feeds a label.
Remove the label and press
The printer displays the sensitivity value
that is automatically selected by the
firmware and the range in which the LTS
will work.
Enter
Press again to proceed to the LTS
Test menu.
Enter
Press . The printer feeds a label.
Remove the label. The printer
automatically feeds another label.
Repeat Steps 1 and 2 until you are sure
the LTS is working properly.
Enter
Press to stop the test and exit.
Enter
Press .
Enter a new LTS value within the range
indicated in the LTS Adjust menu (0 to
10).
PX4i and PX6i High Performance Printer User Guide
Enter
again.