Honeywell PX4i User Manual page 67

2. On your PC, open HyperTerminal and set these serial port parameters:
Parameter
Baud Rate
Data Bits
Parity
Stop Bits
3. From the host PC, check the wireless settings. For help, see "Manually
•
•
4. Configure your printer to use the correct SSID and authentication modes. For
5. If you are using certificates for validation, test first without the certificate. Only
6. Verify that the printer is connected to the access point and make sure it has an
Use the following sections to set most of your wireless communication settings.
For more information, see the Fingerprint Command Reference Manual or the IPL
Command Reference Manual.
Configuring 802.11 Wireless Security Using Fingerprint
Use the following procedures to configure 802.11 wireless security parameters on
your printer using Fingerprint.
To configure the printer to use WEP authentication
1. Send the following commands to login as an admin and set the SSID:
the double quote.
PX4i and PX6i High Performance Printer User Guide
Default Setting
9600
8
None
1
Configuring IP Settings" on page 52.
If you are running IPL, send this command to the printer:
<STX><SI>wt<ETX>
If you are running Fingerprint, send these commands to the printer:
setup write "wlan","uart1:"
setup write "8021x","uart1:"
help, see the next section, "Configuring 802.11 Wireless Security Using IPL" on
page 58 or "Configuring 802.11 Wireless Security Using Fingerprint" on
page 55.
after performing this test should you transfer the certificate to the printer. The
printer can accept PEM (.pem), DER (.der), and PKCS #12 (.p12 or .pfx)
certificates.
IP address allocated to it.
run "su -p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID","xxxxx"
where xxxxx can be from 0 to 32 ASCII characters, not including
55