Honeywell PX4i User Manual page 71

To configure the printer to use WPA or WPA2 Enterprise mode
1. Send the following commands to login as an admin and set the SSID:
To enter non-alphanumeric octets, use "%nn," where nn is two hexadecimal digits
representing the value of the character.
Note: The default password for logging in as an admin is "pass." If you have changed the
password, you will need to use your password instead of "pass."
2. Send one of the following commands to enable WPA-802.1x or WPA2-802.1x
3. Send these commands to configure the EAP_TYPE:
this protocol.
4. If you are using TTLS, you may need to send this command to set the TTLS
5. If you are using EAP-FAST, you can use PAC and ACQUIRE_PAC commands.
6. If you are using certificates for validation, here are some commands you may
on the printer and export is the passphrase.
PX4i and PX6i High Performance Printer User Guide
<STX><ESC>.x,su -p pass admin<ETX>
<STX><SI>ws,SSID,xxxxx<ETX>
where xxxxx can be from 0 to 32 alphanumeric characters.
authentication. You should also send the WPA_PSK command that does not
contain a value:
<STX><SI>ws,WPA,OFF<ETX>
<STX><SI>ws,WPA2,ON<ETX>
<STX><SI>ws,WPA_PSK, <ETX>
<STX><SI>ws,EAP_TYPE,xxxx<ETX>
where xxxx can be OFF, LEAP, PEAP, TTLS, or EAP-FAST.
<STX><SI>ws,.EAP_USER,xxxx<ETX>
<STX><SI>ws,EAP_PASS,xxxx<ETX>
where xxxx is the unique username and the unique password for
outer name:
<STX><SI>ws,TTLS_USER,xxxx<ETX>
where xxxx is the outer name.
The PAC setting specifies the PAC file to use for EAP-FAST authentication. The
ACQUIRE_PAC setting checks to see if automatic PAC file provisioning is
enabled. You can set ACQUIRE_PAC to on or off.
• Send the following command to set PAC to use /tmp/my.pac with a pass
phrase of "verysecret":
<STX><SI>ws,PAC,/tmp/my.pac@verysecret<ETX>
• Send the following command to set ACQUIRE_PAC to on:
<STX><SI>ws,ACQUIRE_PAC,ON<ETX>
need to use.
• Send the following commands to set a certificate and enable validation:
<STX><SI>ws,CA_CERT,c:/testCA.pfx@export<ETX>
<STX><SI>ws,VALIDATE,ON<ETX>
where c:/testCA.pfx is the location and name of the certificate
59