Fingerprint Error Messages - Honeywell PX4i User Manual

Fingerprint Error Messages

Message Description
Out of paper The printer is out of paper. Load a new roll of media. For help, see
"Loading Media" on page 5.
Next label not Next label not found
found
Label not taken Label not taken
Out of transfer The printer is out of transfer ribbon. Load a new roll of ribbon. For
ribbon helps, see "Loading Ribbon" on page 38.
Transfer ribbon This is not an error condition. This message briefly appears after a
is installed new roll of transfer ribbon is installed.
Head lifted The printhead is lifted. Lower the printhead.
Cutter does not Open and shut the cutter.
respond
Cutter error1 Open and shut the cutter.
Cutter error2 Open and shut the cutter.
Cutter error3 Open and shut the cutter.
Cutter open Shut the cutter.
LSS too high This error can occur when you run a test feed without any media
installed, or if you have incorrect media settings. Load the printer
with media and select the appropriate media type. For help, see
"Loading Media" on page 5.
LSS too low This error can occur when you run a test feed without any media
installed, or if you have incorrect media settings. Load the printer
with media and select the appropriate media type. For help, see
"Loading Media" on page 5.
Testfeed not The printer did not perform a test feed before it printed out test
done labels. Performing a test feed calibrates the sensor. To perform a
testfeed, press the
No RFID support The optional RFID interface is not installed in the printer.
installed
No tag found No RFID tag has been found.
Pause Mode The print job is paused.
Entered
Setup Mode The printer is in Setup mode.
Entered
IP link error No network connection.
IP configuration The printer is trying to acquire an IP address from the network.
error Wait for the printer to complete the task before taking any action.
Generic DP error In Direct Protocol, you can enable error handling for specific
errors using the ERROR statement. When errors added to the
built-in error handling occur, this event is set. The text included in
the SNMP trap is the standard text corresponding to the error.
88
button.
PX4i and PX6i High Performance Printer User Guide
Ready-to-Work Error
Indicator Number
Status
Blinking 1005
Blinking 1031
Blinking
Blinking 1027
Blinking 1058
Blinking 1022
Blinking 1059
Blinking 1701
Blinking 1702
Blinking 1703
1704
Blinking 1007
Blinking 1008
Blinking 1606
Blinking 1320
Blinking 1321
Blinking
Off
Blinking
Blinking
Blinking