Configuring Alerts - Honeywell PX4i User Manual

Configuring Alerts

Use the Alerts page to view and change the printer alert settings.
To configure alerts
1. Click Printer > Alerts.
2. Change the alert settings:
•
•
•
•
3. Select the Notification method.
4. Click Submit Settings.
Use the following table to understand the Alert Settings.
Setting
Label Not Taken
(Fingerprint only)
Cutter Error
Head Lifted
Out of Ribbon
Pause Mode
Setup Mode
Error Condition
(Fingerprint only)
Application Break
(Fingerprint only)
PX4i and PX6i High Performance Printer User Guide
From the Setting list, choose Enabled or Disabled.
In the text field, specify a Delay repeat.
In the Delay Unit list, select seconds or occurrences.
In the Message text field, enter a message.
Description
Sent when the printed label is not taken from the printer. This setting
applies to label and ticket media and requires an optional label taken
sensor.
There was an error related to the label cutter.
A printer job was sent to the printer while the printhead was lifted.
You have thermal transfer ribbon selected and the printer is out of
ribbon.
The printer is in Pause mode.
The printer is in Setup mode.
An error has occurred in the Fingerprint application. The error does not
have to be critical to the print job for the printer to send this alert.
A running Fingerprint application has been interrupted manually or
because of an error.
69