Table of Contents
Advertisement
Troubleshooting
PCS400R Setup
The following sections provide basic troubleshooting information for the PCS400R.
Equipment Setup Review
• Make sure all connectors and connections are tight and secure on all entertainment system components.
• Check the PCS400R LED. Under standard operating conditions, i.e., when the PCS400R is booted and operating normally, the PWR (Power) LED
on the PCS400R front panel is continuously lit green. If there is a hardware fault, the PWR LED will turn and stay red.
* Note: When power is first applied to the PCS400R, the PWR LED initially flashes red and then turns green (blinking during boot-up).
Network Setup
If the network is configured for DHCP but the PCS400R has not been assigned an IP address, i.e., the Ctrl IP field in the PCS400R System Information
display is blank:
1 Check the Control Port connector on the rear panel of the PCS400R. Make sure the cable connection is tight and secure.
2 Observe the green LED on the Control Port. Once the PCS400R is connected to the network, the LED will be lit continuously.
3 Contact the network administrator to verify the network status and check that the DHCP server is working properly.
35
Hide quick links:
Advertisement
Table of Contents
