Shut Down The System; Reset The System; Exit The Current Session - LG PCS400R Pro:Centric Installation & Setup Manual

Shut Down the System

This command allows you to shut down the system in an orderly manner. Use this command to shut down the PCS400R, for example, if you intend to
physically move the unit from one location to another. It is also recommended that you run this command from the PCS400R Service Port in order to
track detailed shutdown log messages.
* Note: Once you use this command, you must remove power from (i.e., unplug) the unit and then plug the AC power cord back into a pow-
ered AC line receptacle when you are ready to restart the server. It is not possible to restart the server remotely.
1 Log in to the PCS400R as described on page 22.
2 At the Command > prompt, type shut and press Enter.
The system will prompt for confirmation:
Are you sure you want to shut down the system? [y/n]:
3 Either:
• Type y and press Enter to shut down the system immediately. The shutdown typically takes about a minute. When the PCS400R is in its
shutdown state, the front panel LED will blink steadily green.
• Type n and press Enter to return to the Main Menu without shutting down the system.

Reset the System

1 If not already logged in, log in to the PCS400R as described on page 22.
2 At the Command > prompt, type reset and press Enter.
The system will prompt for confirmation:
Are you sure you want to reset the system? [y/n]:
3 Either:
• Type y and press Enter to initiate an immediate reset of the PCS400R. The reset process may take several minutes, after which the system
resumes normal operation.
• Type n and press Enter to return to the Main Menu without resetting the system.

Exit the Current Session

At the Command > prompt, type exit and press Enter to end the current session.
34