LG PCS400R Pro:Centric Installation & Setup Manual page 19

7 Either:
• Type 1 and press Enter to select the Java application.
• Type 2 and press Enter to select the HTML application.
* Note: Select the appropriate application based on the purchase order associated with this server. The software license specifies the Java or
HTML application, and the application type must be set accordingly in this step.
Once you make your selection, the server will display confirmation before initiating a reboot, for example:
You selected the pcd (HTML) application
System will now reboot to run the selected application
8 When the reboot is complete, you should see a new login prompt. Log back in to the server (See step 6).
Once you are logged in, you will see a Command > prompt.
The next step describes how to set static IP addresses for the Control Port and/or Feature Port, if desired/applicable. The Control Port is used for
remote management/communication purposes, while the Feature Port is designated for PCS400R IP output (not applicable if your system is using
RF or ASI output). By default, both ports are configured for DHCP.
* Note: You can press Enter at any PCS400R command prompt to view current menu, if desired.
* Note: To view the server's current configuration settings, type info and press Enter at the Command > prompt. The System
Information display will show the IP address that has been assigned to the Control Port (if the network is configured for DHCP) and the out-
put configuration. See "View System Information" on page 23 for further information.
* Note: If the Control Port network is configured for DHCP but the Control Port IP address is not displayed in the System Information display
(see note above), refer to "Network Setup" troubleshooting information on page 35. If configured, the DHCP server should assign an IP
address to the Control Port once the PCS400R successfully connects to the network.
9 (Optional) Set a static IP address for the Control Port and/or Feature Port.
* Note: For detailed information on this step and additional screen samples, see "Modify Network Settings" on pages 24 to 26.
a) At the Command > prompt, type setip and press Enter.
TCP/IP configuration is performed in the CentOS Network Manager TUI (text-based user interface). The system will display the Network
Manager menu, for example:
b) Select/highlight Edit a connection and press Enter.
c) In the next screen, select/highlight the port you wish to configure and press Enter.
d) With the Edit Connection screen for the selected port on display, add the appropriate IPv4 port IP address in the format xxx.xxx.xxx.xxx/xx,
where the last two digits (after the forward slash) identify the network mask bits for the IP address.
Also, add the gateway, and DNS IP addesses in the format xxx.xxx.xxx.xxx.
19