LG PCS400R Pro:Centric Installation & Setup Manual page 26

8 Complete the following configuration:
• Select/highlight <Add...> and press Enter in the Addresses field. Then, type the appropriate IP address in the format xxx.xxx.xxx.xxx/xx,
where the last two digits (after the forward slash) identify the network mask bits for the IP address.
Also, type the gateway IP address (in the format xxx.xxx.xxx.xxx) in the Gateway field.
* Note : If you do not specify the network mask bits in the port's IP address, as indicated above, the system will not create a local route over
the network interface (unless the interface is used as the system's default route).
• Select/highlight <Add...> and press Enter in the DNS Servers field, and type the primary DNS IP address (in the format xxx.xxx.xxx.xxx). As
required, select <Add...> again and type the secondary DNS IP address.
* Note: The Feature Port IP address MUST be on a different subnet than the Control Port IP address.
9 (Recommended) Change the port configuration for IPv6 from Automatic to Ignore: Select/highlight the IPv6 Configuration field and press Enter.
Then, select Ignore from the drop-down list of options.
10 When you are finished, select/highlight <OK> at the bottom right of the Edit Connection screen and press Enter.
11 Repeat steps 4 to 10 for the second port as required. When you are finished with port configuration, select/highlight <Quit> at the bottom right
of the port selection screen and press Enter to return to the Network Manager menu. To exit the Network Manager and return to the Main Menu
prompt, select Quit and press Enter.
12 If you changed the port configuration, you will need to reset the system. If you are ready to reset the system immediately, at the Command
> prompt, type reset and press Enter (See "Reset the System" on page 34 for further information).
* Note : If you intend to modify additional configuration settings during the current session, you may wait until all changes are complete
before you reset the system.
26