LG PCS100R Pro:Centric Installation & Setup Manual

LG PCS100R Pro:Centric Installation & Setup Manual

Lg server installation & setup guide

Advertisement

PCS100R Pro:Centric™
Server
Installation & Setup Guide
Warranty
P/N: 206-4142 (Rev D)
© Copyright 2011, LG Electronics U.S.A., Inc.

Advertisement

Table of Contents
loading

Summary of Contents for LG PCS100R Pro:Centric

  • Page 1 PCS100R Pro:Centric™ Server Installation & Setup Guide Warranty P/N: 206-4142 (Rev D) © Copyright 2011, LG Electronics U.S.A., Inc.
  • Page 2: Safety Warnings

    CAUTION: Do not attempt to modify this product in any way without written authorization from LG Electronics U.S.A., Inc. Unauthorized modification could void the user’s authority to operate this product.
  • Page 3: Important Safety Instructions

    20. Test Equipment the cart/apparatus combination in order In some cases, LG has supplied or recom- to avoid injury from tip-over. mended the use of test equipment and devic- 13. Refer all servicing to qualified service es for the setup and testing of the equipment.
  • Page 4 IMPORTANT SAFETY INSTRUCTIONS 24. Safety Check (Continued from previous page) Upon completion of any service or repairs to 21. Damage Requiring Service this product, ask the service technician to Unplug this product from the wall power out- perform safety checks to determine that the let and refer servicing to qualified service product is in proper operating condition.
  • Page 5 IMPORTANT SAFETY INSTRUCTIONS PCS100R Installation on a Flat Surface (Continued from previous page) To install the PCS100R on a level surface (table C. Circuit Overloading top, shelf, stacked with other equipment, etc.): Consideration should be given to the con- • Carefully place the PCS100R on a level surface. nection of the equipment to the supply circuit and the effect that overloading of the circuits •...
  • Page 6: Table Of Contents

    Rack Installation ....9 – 10 Setup Checklist 1. Unpack the PCS100R Pro:Centric™ server unit and all accessories. Accessories provided: Power Cord and Adapter 2.
  • Page 7: Pcs100R Product Description

    PCS100R Product Description The PCS100R Pro:Centric server is a stand-alone, remotely-controlled processor/ controller for the Pro:Centric system. This device can be used to capture data from an Internet source, assemble the data as display pages, and output the pages in DTV format over the ASI.
  • Page 8: Rear And Front Panel Overviews

    Rear and Front Panel Overviews PCS100R Rear View ..A S I - O U RS-232 Port Power ASI Out Supply/Cord S O F A R E R E S NETWORK (Ethernet) Disconnect Device Port The AC mains plug is used as the SOFTWARE...
  • Page 9: Rack Installation

    Rack Installation Installing the PCS100R in a Rack 1. Carefully slide the chassis into a standard 19-inch equipment rack. 2. Use all four mounting screws to secure the chassis to the rack (see diagram below). 3. Refer to “Surge Protected Power Strip Requirements” below. Although power is not actually applied to the PCS100R until later during the system setup (see “Typical System Installation”...
  • Page 10 Rack Installation (Cont.) PCS100R PCS100R ASI OUT Power Connector POWER NETWORK PCS100R 12V / 5A ASI-OUT RS-232 ..SOFTWARE RESET Typical modulator/ To AC ASI IN 75 ohm power upconverter unit BNC-to-BNC source coaxial cable Modulator/Upconverter...
  • Page 11: System Setup

    System Setup Refer to the following diagrams, and complete the system installation as described on page 12. Typical Setup Flow Chart for the PCS100R Network Distribution PCS100R System ASI Out Combiner ASI In IF In Coaxial Coaxial Upconverter Modulator Cable Cable Cable IF Out...
  • Page 12: Typical System Installation

    When the boot-up is complete, a System Information display identifies important information about the PCS100R, including the unit serial number, hardware ID (firmware version), software versions, MAC address, and IP address, for example: PCS100R Pro:Centric Server v3.3 001-12090025 Hardware ID: 0.0.0.15 OS version: Linux 2.6.33-zenith-pcs100r...
  • Page 13: Troubleshooting / Specifications

    Troubleshooting / Specifications Troubleshooting If the PCS100R is not connecting to the network, i.e., the IP Address field in the System Information display (see setup procedure on previous page) is blank: 1. Check the NETWORK connector on the rear panel of the PCS100R. Make sure the cable connection is tight and secure.
  • Page 14: Document Revision History / Notes

    Document Revision History / Notes Document Revision History Date Description June 2010 Revision A: New document September 2010 Revision B: Specifications update January 2011 Revision C: System setup update November 2011 Revision D: Surge protected power strip requirements added Product documentation is available online at: www.LGsolutions.com/products. From the Products page, select TVs, Systems &...
  • Page 15: Open Source Software Notice

    Copyright © 2005 Reyk Floeter right notices are available for download. LG Electronics Copyright © 1991 Massachusetts Institute of Technology will also provide open source code to you on CD-ROM for a Copyright ©...
  • Page 16: Warranty

    Broadcast Products Welcome to the LG family! We believe that you will be pleased with your new PCS100R Pro:Centric Server. Please read this warranty carefully, it is a “LIMITED WARRANTY” as defined under Federal Law. This warranty gives you specific legal rights, and you may also have other rights that vary from state-to-state within the U.S.A.

This manual is also suitable for:

Pcs100r pro centric

Table of Contents