Introduction And Specifications - Everlast POWER i-MIG 253DP Operator's Manual

Section 1
Overview of Parameters and Features*
Power i-MIG 253DPi
Amp Adjustment Range
Volt Adjustment Range
Wire Feed Speed
Input Voltage
Welder Type
Wire Roll Size and Diameter
MIG Operation and Type
Burn Back Timer Control
Inductance
Pulse Frequency
Peak Pulse Amps/Volts
Pulse Time On
Memory
MIG Burn Back Duration/Voltage
Hot Start
End Amps/Volts
Torch Trigger Functions/latch
Stick E6010 Capability
Power Cable Length
Accessories**
*See next page for complete electrical and technical data.
**Specifications and packaged accessories subject to change without notice.
10-250 Amps
14-28 Volts in standard mode (Volt value becomes Offset/Trim value –5 to +5 in Synergic Pulse/
Double Pulse Modes)
60 to 600 IPM (.5-15 m/min) Includes "Wire Jog" mode for loading or changing wire without hav-
ing to dispense and waste gas.
220-240V Single phase (208V permissible)
Digitally controlled, IGBT inverter type with Pulse CV GMAW (MIG) and CC Stick functions. Fea-
tures CV Spool Gun or CV Push-Pull gun capability (Spool/Push-Pull Gun optional).
.030"-.045" wire diameter assortment. including select U groove (aluminum/bronze) and V groove
(steel/stainless) drive rolls. Other optional sizes and types available. Equipped with 12" diameter
roll capacity (30-44lb). An 8" adapter is available for use with 10-12 lb. rolls. 4" rolls not support-
ed. (Weights referenced are for commonly sold packages of steel wire for wire diameter)
Synergic standard MIG and Synergic Pulse/Pulse on Pulse MIG function.
Includes V Groove drive rolls for:
.030" to .045" (.8mm to 1.2mm in diameter for Steel, Stainless Steel use.**
Includes U groove drive rolls for:
.040" to .045" (1.0mm to 1.2mm) for Aluminum, and Bronze (brazing) use. **
Additional Drive Rolls may be ordered direct from Everlast ( 2 pc kit). Size and type stamped on
side of the drive roll next to the related groove for easy identification. Synergic Pulse settings for
Mild Steel, Stainless Steel, 40XX series Aluminum, 50XX series Aluminum, and Bronze wires.
.01-.5 seconds
1-10 in whole number increments.
Single: Synergically Controlled
Single: Synergically Controlled Voltage/Offset (Trim). Amps adjusted to suit thickness.
Double: Synergically Controlled Voltage/Offset (Trim). Amps adjusted for each half cycle of pulse
to create "stacking effect" of weld bead.
Single: Synergically Controlled
Save and recall up to 10 programs (0-9)
.01-.5 Seconds 5-20V (-5 to +5 Volt offset/trim value in Synergic Pulse/Double Pulse)
0-200
10-250A /14-28V (-5 to 5 offset)
2T, 4T, 4T Special
No, 6011 only
9.5 ft. (3m)
24 Series MIG torch 9.5 ft. (3m), Work clamp with cable 9.5 ft. (3m)
300 A Stick Torch, with cable (3m) Floating ball type regulator.
9

Introduction and Specifications

Double (Pulse on Pulse): .1 to 9.9 Hz
Range 10-250V
Double (Pulse on Pulse): 10-90% of Peak Pulse setting