Everlast POWER i-MIG 253DP Operator's Manual page 48

Section 2
Setup Guide and component Identification
MIG Control Features of the Power i-MIG 253DPi
Single Pulse and Non-Pulse 2T
WELDING
BURNBACK
2T
TIME VOLTS
PREFLOW
POSTFLOW
Single Pulse and Non-Pulse 4T
WELDING
END
BURNBACK
TIME VOLTS
4T
PREFLOW
POSTFLOW
Single Pulse 4T Special
HOT START
WELDING
END
BURNBACK
TIME VOLTS
4T SPCL
PREFLOW
POSTFLOW
The graphical representation above depicts the motions of the MIG Gun trigger
in relation to the welding mode. Each movement of the MIG gun trigger signals
the unit to start a new phase of the weld cycle. A "press" of the trigger is one
movement represented by the "down" arrow. A "release" of the trigger is an-
other movement of the torch switch and is represented by the "up" arrow. The
4T special mode is not available to standard and synergic non-pulse modes.
48