Introduction And Specifications; Overview Of Parameters And Specifications - Everlast POWER MTS 221STi Operator's Manual

Section 1
Overview of Parameters and Features*
Power i-MIG 221STi**
MIG/TIG/Stick Amp Range
Volt Adjustment Range MIG
MIG Wire Feed Speed
Input Voltage
Welder Type
Wire Roll Size and Diameter
Pre/Post Flow Control MIG/TIG
Up/Down Slope of MIG Volts/ TIG Amps MIG: 0-1 Second; TIG: 0-10 Seconds
Synergic MIG/Manual MIG
MIG Burn Back Timer Control
Inductance/Arc Force Control
TIG Output Type
AC TIG Frequency
AC Balance
TIG Pulse Frequency
Base Pulse TIG Amps
TIG Pulse Time On/Balance
Memory
MIG Burn Back Timer
Stick Hot Start Timer
Stick Hot Start Intensity Control
Stick E6010 Capability
Power Cable Length
Accessories**
Weight, Nominal Dimensions
Recommended Generator minimum*** 240V: 8500W Surge, 120V: 4500W Surge
*See next page for complete electrical and technical data.
**Due to minor changes in manufacturing and suppliers of accessories, specifications and accessories subject to change without notice.
***Any use with a generator must be used with a generator rated as providing "clean power" by the generator manufacturer. This is typically
less than 5% THD. Any use with a generator not certified by its manufacturer as providing clean power may render the warranty void.
120V: MIG 30-125A/ TIG DC: 10-125A, AC: 20-150A / Stick 10-120A
240V: MIG 30-200A/ TIG DC: 10-250A, AC: 20-250A / Stick 10-200A
120V: 15.5-21V 240V: 15.5-26V
120V: 60-400 (.5-10 m/min)
120-240V Single phase (208V permissible)
Digitally controlled, IGBT inverter type with CV Synergic MIG , AC-DC Pulse TIG, CC Stick functions.
.023"-.045" wire diameters possible with optional drive rolls and guns. (.023-.030" Standard equipped)
8" diameter(10-12 lbs.); 4" Diameter supported but reconfiguration of the spool carrier is needed.
MIG: (Pre) 0-10 Seconds/ (Post) 0-10 Seconds; TIG (Pre) 0-10 Seconds/ (Post) 0-10 Seconds
Synergic MIG function for wires from .023" to .045" in diameter, with mild steel, stainless and Aluminum
settings. Synergic feature operates via speed control on MTS version of Spool gun as well. Manual MIG
affords complete and independent control throughout the range of all MIG functions with no factory
programmed settings.
0-2 seconds
0-100%
AC/DC with Pulse Control and Wave Form Selection (Advanced Square Wave, Triangular)
20-200Hz
30-70% of Electrode Positive (+)
.5-150Hz
3-95% of Peak Amps
5-95%
Saves up to 9 programs.
0-2 Seconds
0-2 Seconds
0-100% over set amperage
Yes
9.5 ft. (3m)
15 Series MIG torch ( Optional 24 Series) torch 9.5 ft. (3m), 26 Series air-cooled TIG torch, Work clamp
with cable 9.5 ft. (3m). 300 A Stick Torch with cable (3m), Floating ball type regulator.
66 lbs. (bare unit)/30 Kg, Length: 26", Width: 11", Height: 16" (19" with handle)

Introduction and Specifications

240V: 60 to 600 IPM (.5-15 m/min)
9