Trial Operation; Digital Operator Display At Power-Up - Saftronics CIMR-VG5U Installation & Quick Start Manual

2.1

TRIAL OPERATION

To ensure safety, prior to initial operation, disconnect the machine coupling so that the motor is iso-
lated from the machine. If initial operation must be performed while the motor is still coupled to the
machine, use great care to avoid potentially hazardous conditions. Check the following items before a
trial run:
· Wiring and terminal connections are proper.
· Wire clippings and other debris removed from the unit.
· Screws are securely tightened.
· Motor is securely mounted.
· All items are correctly grounded.

Digital Operator Display at Power-Up

When the system is ready for operation, turn ON the power supply. Verify that the inverter powers up
properly. If any problems are detected, turn OFF the power supply immediately. The digital operator
display illuminates as shown below when the power supply is turned ON.
DRIVE FWD
Frequency Ref
U1-01 = 0.00 Hz
DIGITAL OPERATOR
JVOP-130 U
LOCAL
REMOTE
JOG
FWD
REV
RUN
VG5 Installation & Quick-Start Manual
REV REMOTE
SEQ REF
MENU ESC
DATA
ENTER
RESET
STOP
Figure 14 Digital Operator Display at Power-up
Mode Indicator LEDs: DRIVE
FWD/REV
REMOTE (SEQ/REF)
Display Section: Displays frequency reference.
Operation Indicator LEDs:
Chapter 2 - Operation

Trial Operation

Stop LED ON.
39