Turntable Operation; Basic Operation - Victrola VTA-60 Instruction Manual

ASSEMBLY OF THE DUST COVER
1. Remove protective plastic film from the DUST COVER.
2. Align the DUST COVER (#28) to the DUST COVER HINGE (#20), on the
back of the unit. Then, push down the dust cover gently to clip into the
hinges.

BASIC OPERATION

Before use, be sure to remove the white stylus guard off of the needle. Always
make sure that the tone arm is unlocked and free to move across the record
while operating. Lock the tone arm in place again when it is not in use.
1. Press the MODE BUTTON to PHONO mode, the LED DISPLAY will
indicate "PH".
2. Place a record on the TURNTABLE PLATTER and select the desired
speed (33/45/78) by sliding the SPEED SELECTION SWITCH according to
the record.
NOTE: When playing a 45 RPM record, use the included 45 RPM
ADAPTOR located in the holder near the tone arm.
3. Open the TONE ARM CLIP to release the TONE ARM. Push the LIFT
LEVER backward to raise the TONE ARM and gently move the TONE
ARM to the desired position over the record. The turntable will begin to spin
when the arm is moved toward the record. Push the LIFT LEVER forward
to lower the TONE ARM slowly onto the desired position on the record to
begin playing the record.
NOTE: The record will begin to spin only when the tone arm is moved over
the record if the Auto Stop is turned on.
If the AUTO AND MANUAL STOP SELECTION SWITCH is turned ON, the
record will stop automatically when finished. If this switch is at OFF position,
record will continue to spin.
4. To select the volume level, turn the VOLUME CONTROL KNOB to adjust
the volume.
How to Replace the Turntable Stylus (Replacement Needle # ITNP-Y2)
The stylus should last about 50 hours under normal use. However, it is
recommenced that the stylus be replaced as soon as you notice a change in
sound quality. Prolonged use of a worn-out stylus may damage the record.
The highest speed of 78 RPM records would wear out the stylus more quickly.

TURNTABLE OPERATION