Victrola VTA-60 Instruction Manual page 9

NOTE: THIS UNIT NOT ONLY PLAYS COMMERCIAL COMPACT DISCS
BUT ALSO SELF-COMPILED CD-RW DISCS.
PLEASE READ THIS IMPORTANT INFORMATION:
CD mechanisms used in devices like this are designed to fully read all
commercial CDs. They will also read self-compiled CD-R/CD-RW discs but it
may take up to 10 seconds for playback to start. If playback does not start, it is
likely due to the quality of the CD-R/RW disc and/or the compatibility of the CD
compilation software. Manufacturer is not responsible for the playback quality
of CD-R/RW discs.
Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a
malfunction.
PLAYING A CD
1. Press the MODE BUTTON to CD mode, the LED DISPLAY will
indicate "CD".
2. Press CD DOOR OPEN/CLOSE BUTTON to open the disc tray.
3. Carefully place an audio CD with its label side upward on the tray.
4. Press CD DOOR OPEN/CLOSE BUTTON to close the tray, the LED
DISPLAY will indicate the number of tracks on the disc. If there is no disc
inserted, it will indicate "no".
5. Press PLAY/PAUSE to start playing the first track.
6. To pause playback, press the PLAY/PAUSE BUTTON. To resume playing
press PLAY/PAUSE BUTTON again.
7. You can choose to play your favorite track directly by pressing either the
PREV BUTTON or NEXT BUTTON. The LED DISPLAY will indicate the
current track number selected.
8. To locate a particular section within a track, press and hold the PREV
BUTTON or NEXT BUTTON until the section is found. Release the button
to continue playing your selection.
9. To stop playing, press the STOP BUTTON.
REPEAT MODE
REPEAT 1
When the REPEAT BUTTON is pressed once, the REPEAT LED INDICATOR
on the LED DISPLAY will flash in RED. The current selected track will be played
on repeat.
REPEAT ALL
When the REPEAT BUTTON is pressed twice, the REPEAT LED INDICATOR
on the LED DISPLAY will light up in RED. The whole disc will be played on
repeat.
CD PROGRAM PLAY MODE
This function allows the CD tracks to be played in a programmed sequence.
NOTE: Program can only be set in STOP mode.
1. Load the CD Disc you wish to program.
2. Make sure the unit is in STOP mode by pressing the STOP BUTTON.
CD OPERATION