Turntable Operation; Power Supply; Basic Operation; How To Replace The Turntable Needle - Victrola Canvas VSC-400SB Instruction Manual

POWER SUPPLY

Insert the adaptor plug into the DC IN jack on the rear of the unit, then connect the
AC/DC adaptor (5V/1A AC 100-240V, 50-60Hz) to a AC/DC wall outlet.

BASIC OPERATION

1. Lift the BUCKLE on the front of the turntable and open the lid.
2. Turn the FUNCTION KNOB to the PHONO position. Power ON the unit by
turning the VOLUME CONTROL KNOB clockwise. The red LED will light to
show that the turntable is turned ON.
3. Place a record on the TURNTABLE PLATTER and select the desired speed
(33 1/3 / 45 / 78) by sliding the SPEED SELECTION SWITCH according to the record.
NOTE: When playing a 45 RPM record, use the included 45 RPM ADAPTOR
located in the holder near the tone arm.
4. Open the TONE ARM CLIP to release the TONE ARM. Push the LIFT LEVER
backwards to raise the arm. Gently move the tone arm to the desired position
over the record. The turntable will begin to spin when the arm is moved toward
the record. Push the lift lever forward and lower the arm slowly onto the desired
position on the record to begin playing.
Please Note: The record will begin to spin only when the tone arm is moved over
the record if the Auto Stop is turned ON.
5. If the AUTO AND MANUAL STOP SELECTION SWITCH is turned ON, the record
will stop automatically when finished. If this switch is OFF the record will NOT
stop automatically when finished.
6. To select the volume level, turn the VOLUME CONTROL KNOB to adjust the volume.
HOW TO REPLACE THE TURNTABLE STYLUS (Replacement Stylus # VND-08)
Removing the Stylus from the Cartridge
1. Using your fingers, hold at point "A"
and push down point "B"
WARNING: When applying force to stylus,
too much may damage or break the stylus.
2. Continue to push down until the stylus
separates from the front of the cartridge.
3. Remove the rear of the stylus carefully
from the cartridge.
Installing the Stylus
1. Follow the previous steps but in reverse.
Caution:
� Do not remove or bend the stylus needle.
� Do not touch the needle to avoid injury to your hand.
� Turn off the unit's power before you replace the stylus.
� Keep out of reach of children.
Please note: The stylus should last about 50 hours under
normal use. It is recommended that the stylus be replaced
as soon as you notice a change in sound quality

TURNTABLE OPERATION

5