Getting Started - Victrola VTA-60 Instruction Manual

! Do not touch the lens or poke at it. If you do, you may damage the lens and
the player may not operate properly.
! Do not put anything in the safety slot. If you do, the laser diode will be ON
when the CD door is still open.
! If the unit is not to be used for a long period of time, make sure that all power
sources are disconnected from the unit. Remove all batteries from the
battery compartment.
! This unit employs a laser. The use of controls or adjustment or performance
of procedures other than those specified here may result in exposure to
hazardous radiation.
! Should any trouble occur, remove the power source and refer servicing to
qualified personnel.
CAUTION
:
This unit should not be adjusted or repaired by anyone except qualified service
personnel.
- English:
This device complies with Industry Canada's license-exempt RSS. Operation
is subject to the following two conditions: (1) This device may not cause
interference, and (2) This device must accept any inference, including
inference that may cause undesired operation of the device.
- French:
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
SET UP
An AC/DC adaptor with an output of 12 DC 2.0A is included with the unit. This
adaptor is required for operating the unit.
1. Firmly and securely insert the DC plug of the adaptor to the DC IN jack on
the back of the unit.
2. Plug the adaptor's AC plugs into a power outlet rated at 120V AC~60Hz.
The POWER LED INDICATOR will light up in RED.
3. Press and hold the Power On/Off Button to turn on the unit. The POWER
LED INDICATOR will turn off.
IC WARNING

GETTING STARTED