Table of Contents
Advertisement
User's Manual of IMG-120T
CHAPTER 5. COMMAND LINE INTERFACE
5.1 Accessing the CLI
When accessing the management interface for the Industrial Modbus Gateway via a remote Telnet connection,
the Industrial Modbus Gateway can be managed by entering command keywords and parameters at the prompt.
Using the Industrial Modbus Gateway's command line interface (CLI) is very similar to entering commands on an
UNIX system.
This chapter describes how to use the Industrial Modbus Gateway Command Line Interface (CLI) via a remote
Telnet connection.
5.2 Telnet Login
The following shows how to start up the Remote Telnet Management of the Industrial Modbus Gateway. Note
the Industrial Modbus Gateway is configured through an Ethernet connection. Please make sure the manager PC
must be set to the same IP subnet address.
For example, the default IP address of the Industrial Modbus Gateway is 192.168.0.100, then the manager PC
should be set to 192.168.0.x (where x is a number between 1 and 254, except 100) and the default subnet mask
is 255.255.255.0.
Logging in to the Industrail Modbus Gateway
1. Access Command Prompt and enter
telnet 192.168.0.100
to access the Telnet interface.
2. When the following dialog box appears, please enter the default user name and password "admin". The login
screen in Figure 5-1 appears.
Default Username: admin
Default Password: admin
Figure 5-1: Telnet Login Screen
1. After entering the username and password, the telnet main screen appears as Figure 5-2 shows.
-67-
Advertisement
Table of Contents
